INSPECTION AGREEMENT Accept agreement Pre-purchase Standard Inspection Individual Title Property Requirement for Inspection agreement AS 4349.1 - 2007 requires that an inspection agreement be entered into between the inspector & the client prior to the conduct of the inspection. This agreement sets out specific limitations on the scope of the inspection and on limits that apply in carrying it out. Where specific State or Territory requirements apply in addition to the scope of work in this agreement, or where the inspector and client agree to additional matters being covered, that additional scope is listed at the end of this agreement. It is assumed that the existing use of the building will continue. AS 4349.1 - 2007 requires that the basis for comparison is a building of similar age and similar type to the subject building and which is in reasonable condition, having been adequately maintained over the life of the building. This means that building being inspected may not comply with Australian Standards, building regulations or specific state or territory requirements applicable at the time of the inspection. Purpose of inspection The purpose of the inspection is to provide advice regarding the condition of the property at the time of the inspection. Access limitations Areas where reasonable entry is denied to the inspector or where reasonable access is not available are excluded from and do not form part of the inspection. Access limitations may include legal right of entry, locked doors, security system, pets, furniture or other obstructions. Physical access limitations may include height, narrow boundary clearance, thick vegetation, small roof or crawl space and adverse weather conditions. The report shall identify any area or item within the scope of the inspection that was not inspected and the factor that prevented inspection. The extent of accessible areas shall be determined by the inspector at the time of inspection based on the conditions encountered at that time. The inspection shall include only accessible areas and areas that are within the inspector’s line of sight and close enough to enable reasonable appraisal. Reasonable access includes a prerequisite that the minimum clearances specified in the table below are safely available. DIMENSIONS FOR REASONABLE ACCESS Area Access Hole Crawl Space Height Roof Interior 400mm x 500mm 600mm x 600mm Accessible from a 3.6m ladder Roof Exterior Accessible from a 3.6m ladder placed on the ground NOTES: 1 Reasonable access does not include the cutting of access holes or the removal of screws and bolts or any other fastenings or sealants to access covers.2 Sub-floor areas sprayed with chemicals are not be inspected unless it is safe to do so. Conditions An inspection report may be conditional on prevailing weather conditions or recent occupancy and use of services that might affect observations information provided by the client or the agents of the client deliberate concealment of defects any other relevant factor limiting the inspection Scope of inspection What is not reported on - general exclusions detailed in the standard AS 4349.1 - 2007 Parts of a building that are under construction. The inspection is not intended to include rigorous assessment of all building elements in a property. Defects that would only be apparent under particular weather conditions or when using particular fittings & fixtures. Defects not apparent due to occupancy or occupancy behavior eg non use of a leaking shower. The inspection report is not a certificate of compliance of the property within the requirements of any Act, regulation, ordinance, local law or by-law and is not a warranty against problems developing with the building in the future. Unauthorized building work or of work not compliant with building regulations. Title and ownership matters, matters concerning easements, covenants, restrictions, zoning certificates and all other law-related matters. Estimation of the cost of rectification of specific defects. What is not reported on - specifics excluded by the standard AS 4349.1 - 2007 Footings below ground, concealed damp-proof course, electrical installations, operation of smoke detectors, light switches and fittings, TV, sound and communication and security systems, concealed plumbing, adequacy of roof drainage as installed, gas ittings and fixtures, air conditioning, automatic garage door mechanisms, swimming pools and associated filtration and similar equipment, the operation of fireplaces and solid fuel heaters, including chimneys and flues, alarm systems, intercom systems, soft floor coverings, electrical appliances including dishwashers, incinerators, ovens, ducted vacuum systems, paint coatings except external protective coatings, health hazards e.g., allergies, soil toxicity, lead content, radon, presence of asbestos or urea ormaldehyde), timber and metal framing sizes and adequacy, concealed tie downs and bracing, timber pest activity, other mechanical or electrical equipment (such as gates, soil conditions, control joints, sustainable development provisions, concealed framing-timbers or any areas concealed by wall linings or sidings, landscaping, rubbish, floor cover, furniture and accessories, stored items, insulation, environmental matters e.g. BASIX, water tanks, BCA environmental provisions, energy efficiency, lighting efficiency. What is reported on The inspection includes subjective appraisal by an inspector competent to assess the condition of residential buildings. It involves a subjective assessment so different inspectors or even the same inspector on a different occasion may reach different conclusions. The inspection comprises a visual assessment of the property to identify major defects and to form an opinion regarding the general condition of the property at the time of inspection. The following areas shall be inspected where applicable: The interior of the building: ceilings; walls; floors; windows; doors & frames; kitchen; bathroom; wc; en-suite; laundry; stairs & damp problems The exterior of the building: walls (including lintels, claddings, doors & windows); timber or steel frames & structures; chimneys; stairs; balconies, verandas, patios, decks, suspended concrete floors, balustrades The roof exterior: roof (including tiles, shingles & slates, roof sheeting, gables, flashings); skylights, vents, flues; valleys; guttering; downpipes; eaves, fascias and barges The roof space: roof covering; roof framing; sarking; party walls; insulation The sub-floor space: timber floor (including supports, floor, ventilation, drainage, damp); suspended concrete floors The property within 30m of the house and within the boundaries of the site: car accommodation, detached laundry, ablution facilities and garden sheds; retaining walls (where supporting other structures and landscaping retaining walls > 700mm high); paths & driveways; steps; fencing (general & swimming pool) ; surface water (drainage effectiveness) The scope of the inspection includes variations to the exclusions in AS 4349.1 - 2007 as detailed above. Pre-purchase Timber Pest Inspection Accept agreement Pre-purchase Timber Pest Inspection Individual Title Property Requirement for Inspection agreement The Pre-purchase Timber Pest Inspections and all Timber Pest Inspections the inspection will be in accord with the requirements of Australian Standard AS 4349.3-2010 Inspection of buildings.The purpose of the inspection is to provide advice about the condition of the property concerning timber pest activity as outlined in the Scope of this Agreement. The inspection WILL NOT involve any invasive inspection including cutting, breaking apart, dismantling, removing or moving objects including, but not limited to, roofing, wall and ceiling sheeting, ducting, foliage, mouldings, debris, roof insulation, sarking, sisalation, floor or wall coverings, sidings, fixtures, floors, pavers, furnishings, appliances or personal possessions. The inspector CANNOT see or inspect inside walls, between floors, inside skillion roofing, inside the eaves, behind stored goods in cupboards, in other areas that are concealed or obstructed. Insulation in the roof void may conceal the ceiling timbers and make inspection of the area unsafe. The inspector WILL NOT dig, gouge, force or perform any other invasive procedures. An invasive inspection will not be performed unless a separate contract is entered into. If the property to be inspected is occupied then you should be aware that furnishings or household items may be concealing evidence of Timber Pests, which may only be revealed when the items are moved or removed. In some case the concealment may be deliberate. If You are the purchaser and not the owner of the property to be inspected then You should obtain a statement from the owner as to any timber pest activity or damage to the property known to them and what, if any, treatments have been carried out to the property. It is important to obtain copies of any paperwork issued and the details of any repairs carried out. Ideally the information obtained should be given to the inspector prior to the inspection being conducted. SCOPE OF THE INSPECTION & REPORT: In the case of Pre-purchase Timber Pest Inspections or Timber Pest Inspections in accord with AS 4349.3- 2010 the Inspection and resulting Report will be confined to reporting on the discovery, or non-discovery, of infestation and/or damage caused by subterranean and dampwood termites (white ants), borers of seasoned timber and wood decay fungi (rot), present on the date and time of the inspection. The inspection will not cover any other pests and the Report will not comment on them. Dry wood termites (Family: KALOTERMITIDAE) and European House Borer (Hylotrupes bujulus Linnaeus) will be excluded from the Inspection. 13. The inspection will report any evidence of a termite treatment that happens to be found. Where evidence of a treatment is reported then the Client should assume that the treatment was applied as a curative and not as a preventative. You should obtain a statement from the owner as to any treatments that have been carried out to the property. It is important to obtain copies of any paperwork issued. MOULD: Mildew and non-wood decay fungi are commonly known as Mould and is not considered a Timber Pest but may be an indicator of poor ventilation or the presence of termites, wood decay or water leaks. Mould and their spores may cause health problems or allergic reactions such as asthma and dermatitis in some people. LIMITATIONS: Nothing contained in the Report will imply that any inaccessible or partly inaccessible area(s) or section(s) of the property are not, or have not been, infested by termites or timber pests. Accordingly the Report will not guarantee that an infestation and/or damage does not exist in any inaccessible or partly inaccessible areas or sections of the property. Nor can it guarantee that future infestation of Timber Pests will not occur or be found. If the property to be inspected is occupied then you must be aware that furnishings or household items may be concealing evidence of problems, which may only be revealed when the items are moved or removed. DETERMINING EXTENT OF DAMAGE: The Report will not and cannot state the extent of any timber pest damage. If any evidence of Timber Pest activity and/or damage resulting from Timber Pest activity is reported either in the structure(s) or the grounds of the property, then. You must assume that there may be some structural or concealed damage within the building(s). An invasive Timber Pest Inspection (for which a separate contract is required) should be carried out and you should arrange for a qualified person such as a Builder, Engineer, or Architect to carry out a structural inspection and to determine the full extent of the damage and the extent of repairs that may be required. If Timber Pest activity and/or damage are found, within the structures or the grounds of the property, then damage may exist in concealed areas, e.g. framing timbers. In this case an invasive inspection is strongly recommended. Damage may only be found when wall linings, cladding or insulation are removed to reveal previously concealed timber. You agree that neither we nor the individual conducting the Inspection is responsible or liable for the repair of any damage whether disclosed by the report or not.